recommendations for Deodorizing Pet Odors!
- HAVE PET ODORS!
- NO PROBLEM, YOU JUST FOUND
Pet odors are easily eliminated
with the proper application of C20 and ozone.
If you have a pet odor from urine on the carpet, etc. Crystal air has
the only complete solution available. C20 deodorizer and an ozone generator will
totally eliminate the odor for good.
- For commercial pet odor treatment
jobs you should use .5-2 g/hr ozone for every 100 sq/ft, depending on how
fast the job needs to be done and how bad the problem is. With .5 g/hr / 100
sq/ft you should treat for 1-2 days +, with 2 g/hr / 100 sq/ft it should
only take about 6-12 hours.
- For the do-it-yourself home owner,
the treatments can be done one room at a time to allow the use of a much
smaller unit. Just calculate the size of your largest room to come up with
the size of unit that you will require. Also most home owners are not in as
much of a rush to do the job, if this is so you can probably do the job with
1/4 of the above recommended ozone production.
- Application Procedures:
- Site preparation:
- 1. All damaged items need to be removed
from the area as well as any carpet, pet beds, wall board, or other building
or pet bedding materials that are to be replaced.
- 2. Thoroughly clean all areas possible,
and deodorize with C20
liquid deodorizer (4oz/gallon of water). Allow the
C20 to completely dry, It does its job as it dries. The odor may
actually seem to get worse until it dries due to the fact that C20 is a true
deodorizer and contains no fragrance to "cover" the odor.
- Ensure that the area is soaked in
to the same degree as the original pet urine, this will ensure that the
C20 penetrates to the same depth as the damaging odor is.
- Ozone application:
- Place the ozone generator in an area that
will provide the best circulation and distribution of the ozone. Run an
extension cord from all generators to the receptacle closest to the exit
door. Use auxiliary fans to help with circulation, this will also help to
drive the ozone into the pores of the materials. Turn the generator/s to
full output and to the on position. Leave the premises and lock all
entrances. Allow the ozone application to operate for the above recommended
time. If the problem is especially bad increase the amount of ozone used or
the length of the application accordingly. Upon returning to the premises,
turn off the ozone generators by unplugging the extension cord. Leave the
premises and lock all entrances. Allow the building to sit for 4-8 hrs, this
allows the remaining ozone to convert back to oxygen and reduce ozone
- Special notes on pet odors.
- 1. If the odor originated from urine it is
VERY important to treat with C20 first and make sure that it is soaked in
- 2. If the pets bed is the source of the
odor, or if the pets lived in the area for a long time all porous floor
areas should be treated with C20 prior to the ozone treatment. This will
help in deodorizing the pet dander and body oils that have fallen through
the carpet to the floor board, if this step is not done the odor may come
back and require re treatment.